ADTRAN 1000R Series - Manual (Page 291)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 291
show spanning-tree detail [active]
Use the show spanning-tree detail command to display the spanning-tree protocol information in detail.
Syntax Description
active Optional. Displays spanning-tree protocol information for only active interfaces.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is an example output using the show spanning-tree detail command:
> enable
# show spanning-tree detail
Executing the ieee compatible Spanning Tree protocol
Bridge Identifier has priority 32768, address 00:a0:c8:00:88:41
Configured hello time 2, max age 20, forward delay 15
We are the root of the spanning tree
Number of topology changes 8 last change occurred 00:21:00 ago
from eth 0/24
Times: hold 3, topology change 0, notification 0
hello 2, max age 20, forward delay 15
Timers: hello 1, topology change 0, notification 0, aging 300
Port 4 (eth 0/4) is learning
Port path cost 19, Port priority 128, Port Identifier 128.4.
Designated root has priority 32768, address 00:a0:c8:00:88:41
Designated bridge has priority 32768, address 00:a0:c8:00:88:41
Designated port id is 128.4, designated path cost 0
Timers: message age 0, forward delay 15, hold 3
Number of transitions to forwarding state: 1
BPDU: sent 46, received 0