ADTRAN 1000R Series - Manual (Page 437)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 437
ip policy-class <policyname> max-sessions <number>
Use the ip policy-class command to create an access control policy and enter the access control policy.
Use the no form of this command to delete an access policy and all the entries contained in it.
Syntax Description
<policyname> Identifies the configured access policy using an alphanumeric descriptor
(maximum of 255 characters). All access policy descriptors are case-sensitive.
max-sessions <number> Optional. Configures a maximum number of allowed policy sessions. This number
must be within the appropriate range limits. The limits are either 1 to 4000 or 1 to
30,000 (depending on the type of AOS device you are using).
Default Values
By default, all AOS security features are disabled and there are no configured access lists.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 2.1 Command was introduced.
Configured access policies will only be active if the ip firewall command has been entered
at the Global Configuration mode prompt to enable the AOS security features. All
configuration parameters are valid, but no security data processing will be attempted
unless the security features are enabled.
Before applying an access control policy to an interface, verify your Telnet
connection will not be affected by the policy. If a policy is applied to the interface you
are connecting through and it does not allow Telnet traffic, your connection will be
lost.