ADTRAN 1000R Series - Manual (Page 1176)

Command Reference Guide VLAN Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1176
VLAN I NTERFACE C ONFIG C OMMAND S ET
To activate the VLAN Interface Configuration mode, enter the interface vlan command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface vlan 1
(config-vlan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 1177
arp arpa on page 1180
bandwidth <value> on page 1181
bridge-group <group#> on page 1182
crypto map <mapname> on page 1183
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 1185
ip commands begin on page 1187
mac-address <address> on page 1210
max-reserved-bandwidth <percent> on page 1211
snmp trap on page 1212
snmp trap link-status on page 1213
traffic-shape rate <rate> [<burst>] on page 1214