Show ip igmp groups <group-address – ADTRAN 1000R Series User Manual
Page 222
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
222
show ip igmp groups <group-address>
Use the show ip igmp groups command to display the multicast groups that have been registered by
directly connected receivers using Internet Group Management Protocol (IGMP). If no group address is
specified, all groups are shown with this command.
Syntax Description
<group-address>
Optional. Displays the IP address of a multicast group.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 7.1
Command was introduced.
Usage Examples
The following is sample output from this command:
>enable
#show ip igmp groups
IGMP Connected Group Membership
Group Address
Interface
Uptime
Expires
Last Reporter
172.0.1.50
Loopback100
00:42:57
00:02:50
172.23.23.1
172.1.1.1
Ethernet0/1
00:05:26
00:02:51
1.1.1.2
172.1.1.1
Loopback100
00:42:57
00:02:51
172.23.23.1