ADTRAN 1000R Series - Manual (Page 1036)

Command Reference Guide Port Channel Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1036
switchport trunk native vlan <vlan id>
Use the switchport trunk native vlan command to set the VLAN native to the interface when the
interface is in trunking mode. To return to defaults, use the no version of this command.
Syntax Description
<vlan id> Specifies a valid VLAN interface ID (1 to 4094).
Default Values
By default, this is set to VLAN 1.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
Configure which VLAN the interface uses as its native VLAN during trunking. Packets from this VLAN
leaving the interface will not be tagged with the VLAN number. Any untagged packets received by the
interface are considered a part of the native VLAN ID.
Usage Examples
The following example sets the native VLAN on port channel 1 to VLAN 2:
(config)#interface port-channel 1
(config-p-chan 1)#switchport trunk native vlan 2