ADTRAN 1000R Series - Manual (Page 1298)

Command Reference Guide Community List Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1298
C OMMUNITY L IST C OMMAND S ET
To activate the Community List Configuration mode, enter the ip community-list command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#ip community-list listname
(config-comm-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
All other commands for this command set are described in this section in alphabetical order.
deny on page 1299
permit on page 1300