ADTRAN 1000R Series - Manual (Page 281)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 281
show route-map [<name>]
Use the show route-map command to display any route-maps that have been configured in the router. It
displays any match and set clauses associated with the route-map, as well as the number of incoming
routes that have matched each route-map. Route-maps can be used for BGP and PBR.
Syntax Description
<name> Optional. Displays only the route-map matching the specified name.
Default Values
By default, this command displays all defined route-maps.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
In the example below, all route-maps in the router are displayed.
>enable
#show route-map
route-map RouteMap1, permit, sequence 10
Match clauses:
community (community-list filter): CommList1
Set clauses:
local-preference 250
BGP Filtering matches: 75 routes
Policy routing matches: 0 packets 0 bytes
route-map RouteMap1, permit, sequence 20
Match clauses:
community (community-list filter): CommList2
Set clauses:
local-preference 350
BGP Filtering matches: 87 routes
Policy routing matches: 0 packets 0 bytes
route-map RouteMap2, permit, sequence 10