ADTRAN 1000R Series - Manual (Page 525)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 525
stack [master | member | vlan] <master> <member> <vlan>
Use the stack command to configure switch-stacking options.
Syntax Description
master Specifies that the unit will be the master of the stack.
<vlan> Configures the private IP network the stack will use for communication.
<IP network> Configures the network mask of the private IP network.
<IP mask> Configures the VLAN over which the private IP network will operate. (2386 is the
default).
member Adds a switch to the stack.
<MAC address> Specifies the MAC address of the unit being added.
<unit id> Specifies the unit ID of the switch being added.
vlan Specifies the management VLAN of the stack of which you are a member.
<vlan> Setting this value puts you in stack member mode, as opposed to stack master
mode.
Default Values
By default, stack vlan is 2386, and the stack IP network is 169.254.0.0/24.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following are variations of the stack command:
This example configures the unit to be the stack master and use the default stack VLAN and IP network.
(config)#stack master 2000
This example configures the unit to be the stack master and use VLAN 2000 as the management VLAN
and 192.168.1.0/24 as the management network.
(config)#stack master 2000 192.168.1.0 255.255.255.0