ADTRAN 1000R Series - Manual (Page 1033)

Command Reference Guide Port Channel Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1033
switchport trunk allowed vlan [add | except | remove] <vlan id list> [all]
Use the switchport trunk allowed vlan command to allow certain VLANs to transmit and receive traffic
on this port when the interface is in trunking mode. To return to defaults, use the no version of this
command.
Syntax Description
add Adds the specified VLAN IDs to the VLAN trunking allowed list.
except Adds all configured VLAN IDs to the VLAN trunking allowed list except those
specified in the <vlan id list>.
remove Removes VLAN IDs from the VLAN trunking allowed list.
<vlan id list> Specifies a list of valid VLAN interface IDs. Refer to Functional Notes below for
additional syntax considerations.
all Adds all configured VLAN IDs to the VLAN trunking allowed list.
Default Values
By default, all valid VLANs are allowed.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
A VLAN list is a set of VLAN IDs. A valid VLAN ID value must be from 1 to 4094 (inclusive). Each VLAN ID
in a list is delimited by commas, yet a range of IDs may be expressed as a single element by using a
hyphen between endpoints. For example the VLAN ID range 1,2,3,4,6,7,8,9,500 may be more easily
expressed as 1-4,6-9,500. No spaces are allowed in a valid ID range.
Usage Examples
The following example adds VLANs to the previously existing list of VLANs allowed to transmit and receive
on this port:
(config)#interface port-channel 1
(config-p-chan 1)#switchport trunk allowed vlan add 1-4,7-9,500