ADTRAN 1000R Series - Manual (Page 289)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 289
show spanning-tree active [detail]
Use the show spanning-tree active command to display the spanning-tree status on active interfaces only.
Syntax Description
detail Optional. Displays the spanning-tree protocol status in detail.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is an example output using the show spanning-tree active command:
>enable
#show spanning-tree active
Spanning Tree enabled protocol ieee
Root ID Priority 32768
Address 00:a0:c8:00:88:41
We are the root of the spanning tree
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address 00:a0:c8:00:88:41
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
eth 0/9 Desg FWD 19 128.9 P2p
eth 0/24 Desg FWD 19 128.24 P2p
Interface
-------------------
Role
-------------------
Sts
------------------
Cost
-----------
Prio.Nbr
-------------
Type
---------------
eth 0/2 Desg FWD 19 128.2 P2p
eth 0/3 Desg FWD 19 128.3 P2p
eth 0/9 Desg FWD 19 128.9 P2p