ADTRAN 1000R Series - Manual (Page 1067)

Command Reference Guide PPP Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1067
hold-queue <queue size> out
Use the hold-queue out command to change the overall size of an interface's WAN output queue.
Syntax Description
<queue size> Specifies the total number of packets the output queue can contain before packets
are dropped. Range 16 to 1000.
Default Values
The default queue size for WFQ is 400. The default queue size for PPP FIFO and Frame Relay
round-robin is 200.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example sets the overall output queue size to 700:
(config)#interface ppp 1
(config-ppp 1)#hold-queue 700 out