ADTRAN 1000R Series - Manual (Page 317)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 317
telnet stack-member <unit id>
Use the telnet stack-member command to Telnet to a stack member.
Syntax Description
<unit id> Specifies unit ID of the stack member to connect to via a Telnet session.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 8.1 Command was introduced.
Functional Notes
This command is only available when in stack-master mode.
Usage Examples
The following example Telnets to a member of the stack:
>enable
#telnet stack-member 3
Trying Stack Member 3...Press Ctrl+C to abort