Show atm [pvc | traffic] interface atm <interface – ADTRAN 1000R Series User Manual
Page 160
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
160
show atm [pvc | traffic] interface atm <interface>
Use the show atm command to display information specific to the asynchronous transfer mode (ATM)
interface.
Variations of this command include the following:
show atm pvc
show atm pvc interfaces atm <interface>
show atm traffic interface atm <interface>
Syntax Description
pvc
Displays ATM PVC information.
traffic
Displays ATM traffic information.
<sub-interface number>
Displays the ATM PVC information, for the specified sub-interface (x.x) number.
<atm port interface>
Displays the ATM port traffic information, for the specified ATM port number
(valid range: 1 to 1023).
<atm vcl interface>
Displays the ATM VCL traffic information, for the specified ATM VCL number
(valid range: 1 to 1023).
Default Values
No default is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 8.1
Command was introduced.
Usage Examples
The following is sample output from this command:
>enable
#show atm pvc interface atm 1.1
Encap
Peak
Avg/Min Burst
Name
VPI
VCI
Type
SC
Kbps
Kbps
Cells
Status
atm 1.1
0
200
SNAP
N/A
0
0
0
Active