ADTRAN 1000R Series - Manual (Page 893)

Command Reference Guide Frame Relay Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 893
frame-relay fragment <threshold>
Use the frame-relay fragment command to set the FRF.12 fragmentation threshold. Use the no form of
this command to erase the configured threshold.
Syntax Description
<threshold> Specifies the fragmentation threshold. Valid fragmentation thresholds are greater
than or equal to 64 and less than or equal to 1600.
Default Values
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 6.1 Command was introduced.
Functional Notes
For Frame Relay fragmentation to take effect, rate-limiting must be enabled by setting the committed burst
rate and excessive burst rate. Refer to
frame-relay bc <committed burst value> on page 891 and
frame-relay be <excessive burst value> on page 892 for more information.
Usage Examples
The following example enables FRF.12 fragmentation on a sublink:
(config)#interface frame-relay 1.16
(config-fr 1.16)#frame-relay bc 64000
(config-fr 1.16)#frame-relay be 16
(config-fr 1.16)#frame-relay fragmentation 100
The following example disables FRF.12 fragmentation on a sublink:
(config)#interface frame-relay 1.16
(config-fr 1.16)#no frame-relay fragment