ADTRAN 1000R Series - Manual (Page 1239)

Command Reference Guide Crypto Map Manual Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1239
C RYPTO M AP M ANUAL C OMMAND S ET
To activate the Crypto Map Manual mode, enter a valid version of the crypto map ipsec-manual
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto map Map-Name 10 ipsec-manual
(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description <text> on page 31
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 1240
ike-policy <policy number> on page 1241
match address <listname> on page 1242
set peer <address> on page 1244
set session-key [inbound | outbound] on page 1245
set transform-set <setname> on page 1249
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.