Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set User Manual
Page 128
Section 3B
Power Distribution
3B-7
Connecting Main Power Supply to the Color Operator Panel
You connect the operator panel power supply directly to the main power
supply. The operator panel power supply receives power from the color
CRT power supply through an internal jumper from the AC (H and L)
terminals.
Figure 3B.5
Color Operator Panel Power Supply Connection
5 V
G N D
5 V
G N D
5 V
G N D
1 2 V
G N D
A C
T o H P G
T o H P G
T o H P G
T o M T B p a n e l
I/O m o d u le
19450
L1
L2
AC
PE
HPG
GND
5V
5V
HPG
HPG
MTB
GND
GND
12V
GND
5V
BT02
L1
L2
Connect terminals AUX-AC H and L of terminal block BT04 on the
main power supply to the color CRT power supply terminals AC H and
AC L, which are located on the rear of the color operator panel, using the
power supply cable C03.
Important: The chassis ground terminal connects to the operator panel
chassis and designated cable shields. Power supply common is AC
coupled to chassis ground. It is the user’s responsibility to determine if a
direct connection to cabinet ground bus is required.