Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 471)

Section 9A
Operator Interface
9A-4
The mounted operator panels are typically mounted directly in a cabinet
and are fixed in their location. It is directly linked to the 9/Series fiber
optic ring, and contains its own power supply. The video signal is
connected directly through a cable from the main processor to the CRT.
Figure 9A.2 shows the connectors and terminal blocks of the monochrome
operator panel.
Figure 9A.2
Monochrome Operator Panel Connectors and Terminal Blocks
5V
GND
5V
GND
5V
GND
GND
AC
To HPG
To HPG
HPG
12V
Rear
Operator
Panel
Front
CN19M
Optical in
OP04
Optical out
OP03
To
BT02
To MTB Panel
I/O Module
L1
PE
L2
9A.2
Mounted Operator Panel
Installation