Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 85)

Section 3A
Primary 9/230 Components
3A-2
The processor board is attached to the mounting plate. Refer to
Figure 3A.1 and Figure 3A.2 for the processor board identification.
Figure 3A.1
Front View of the 9/230 Analog Processor
Processor
Board
J1 J2 J3 TB2
19422
INPUT
11 5/230 V
8A /5.5A
47 --6 3Hz
cable tie down holes
earth ground screws
Lithium Battery Connector
I/O Ring Output
Connector (red)
I/O Ring Input
Connector (black)
E-STOP Terminal
Port B (RS232/422)
Spare Fuse
Lithium Battery Pack
Video Connector
Analog Out
Port
Main
Power
Supply
Power Supply Connector Flash Memory SIMMs
Servo Connectors
(only J1 is available on 1 axis 9/230)
DS2 DS4
LEDs
Remote I/O Port
Figure 3A.2
Side View of the 9/230 Digital with Power Supply Cut Away
“Run”LED
Lithium Battery Connector
I/O Ring Output
Connector (red)
I/O Ring Input
Connector (black)
E-STOP Terminal
Port B
(RS232
/422)
Spare Fuse
Video
Connector
Power Supply Connector
Flash Memory SIMMs
Main Power Supply
Back Plate
Touch Probe Connector
Analog Out Port
Power Supply Cut Away to Show
Servo
and Fiber Optic Connectors
Servo Connectors
J1 J2 J3
3A.1
The Processor Board