Facit n4000 tape reader/punch connection, Decitek ab 8000- xpdr connection – Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set User Manual
Page 450
Advertising
Section 8
Communication Interface
8-17
3. Facit N4000 Tape Reader/Punch Connection
The recommended configuration of the Facit N4000 Tape Reader/Punch is
shown below:
Configuration Parameter
Setting
DEVICE:
FACIT N4000
PORT TYPE:
RS232C
BAUD RATE:
2400
PROTOCOL:
LEVEL_2*
PARITY:
EVEN
STOP BITS:
1
DATA LENGTH:
8
TIMEOUT:
15 SEC
OUTPUT CODE
ASCII
The Facit N4000 Tape Reader/Punch is connected to the control using a
standard RS-232 with hardware handshake interface cable (see Figure 8.2).
4. Decitek AB 8000- XPDR Connection
The recommended configuration of the Decitek AB 8000-XPDR tape
reader is shown below:
Configuration
Parameter
Setting
DEVICE:
DECITEK AB 8000-XPDR
PORT TYPE:
RS232C
BAUD RATE:
2400
PROTOCOL:
LEVEL_2*
PARITY:
EVEN
STOP BITS:
1
DATA LENGTH:
8
TIMEOUT:
15 SEC
OUTPUT CODE
N/A
Advertising