Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 87)

8
1
15
9
11257-I
Section 3A
Primary 9/230 Components
3A-4
Video Monitor Connector
The video monitor connector is used to interface the video monitor with
the control. Figure 3A.4 shows this connector and lists the pin assignments
of this connector.
Figure 3A.4
Video Monitor Connector J8 and (has pin sockets) Pin Assignments
Pin No. Signal Name Pin No. Signal Name
1 GND (SHIELD) 9 RED (L)
2 RED (H) 10 GREEN (L)
3 GREEN (H) 11 BLUE (L)
4 BLUE (H) 12 NC
5 NC 13 CLOCK (L)
6 CLOCK (H) 14 H-SYNC (L)
7 H-SYNC (H) 15 V-SYNC (L)
8 V-SYNC (H)
Touch Probe Connector (TB2)
The control module receives touch probe feedback through the connector
labeled TP (TB2). Figure 3A.5 shows the location of the TP connector.
Table 3A.B lists the terminal assignments of this connector.
Figure 3A.5
Touch Probe, 4 Plug-type Terminal Block Connections.
4 3 2 1
1
2
3
4