Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 368)

Section 7A
Connecting Components
7A-20
Table 7A.A
Cable and Connector List (continued)
Cable No. Control From Module and Connector Cable Name To Module and Connector Cat. No.
C05 9/260 and
9/290
Motherboard TB1 E-Stop String Cable Machine Circuits Prepared by Customer
9/230 Processor Board TB1
9/440 (all) System Module TB1
C05
DRIVES ENCLOSURE
MacHINE
Motor thermal switches
Drive System Ready
Remote
E-Stop
button
Extreme
overtravel
switches
E-Stop
Status
Contacts
Customer
E-Stop
String
Reset
Common
E-Stop
TB1
If your control has terminal 8, then
connect it to chassis ground. If terminal 8
is not present on your control, then this
type of grounding is not necessary.
Connector On End of Cable Cable Type Connector On End of Cable Max. Cable Length
Miscellaneous Belden 9407 Miscellaneous Line Drop Limitation