Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 451)

Section 8
Communication Interface
8-18
The switch assemblies on the side and rear of the tape reader must be set as
shown below:
SIDE VIEW REAR VIEW
____________________ ___________________
| | |
| 12345678 | | ON OFF
| SW3 ****|||| | | 4 * -
| ||||**** | | 3 * -
| | | SW1 2 - *
| | | 1 * -
|
|
12 - *
| 11 - *
| 10 - *
| 9 * -
| 8 * -
| SW2 7 * -
| 6 * -
| 5 * -
| 4 - *
| 3 - *
| 2 - *
| 1 * - 11359-I
* Denotes switch lever location
The Decitek AB 8000-XPDR tape reader is connected to the control using
a standard RS-232 with hardware handshake interface cable (see
Figure 8.2).
5. DSI SP75 Connection
The recommended configuration of the DSI SP75 tape punch is shown
below:
Configuration
Parameter
Setting
DEVICE: DSI SP75
PORT TYPE: RS232C
BAUD RATE: 600
PROTOCOL: RAW
PARITY: EVEN
STOP BITS: 1
DATA LENGTH: 8
TIMEOUT: 15 SEC
OUTPUT CODE ASCII
The DSI SP75 tape punch is connected to the control using a standard
RS-232 with hardware handshake interface cable (see Figure 8.2).