Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 374)

Section 7A
Connecting Components
7A-26
Table 7A.A
Cable and Connector List (continued)
Cable No. Control From Module and Connector Cable Name To Module and Connector Cat. No.
C11 9/260 and
9/290
Motherboard P3 Fast I/O Interface Cable Miscellaneous I/O Devices
(examples shown)
Purchased by
customer from
independent vendor.
------------ N/A on the
9/230 and
9/440 (all)
---------------------------------------------- -------------------------------------------- ---------------------------------------- ----------------------------------
Input
#1
Input
#2
Input
#3
Input
#4
Output
#1
Output
#2
Output
#3
Output
#4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
11212-I
Fast_I1
COM
Fast_I2
COM
Fast_I3
COM
Fast_I4
COM
Fast_O1
COM
Fast_O2
COM
Fast_O3
COM
Fast_O4
COM
+
--
+
--
+
--
+
--
+
-- +
--
+
--
+
--
+
--
fast_I1
com
fast_I2
com
fast_I3
com
fast_I4
com
com
com
com
fast_O3
fast_O4
fast_O2
com
fast_O5
Allen-Bradley recommends that you use a terminal block to simplify the
wiring of the fast I/O. Refer to the section on fast I/O in 10A-63.
Allen-Bradley also recommends that you purchase a pre-made cable to
connect the terminal block to the control.
Important: The Fast I/O feature is an application specific feature. For
additional information on this feature contact your Allen-Bradley sales
office.
Connector On End of Cable Cable Type Connector On End of Cable Max. Cable Length
16--pin (has sockets) Ribbon Miscellaneous --------------------