Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 196)

Section 4B
Connecting the 3-axis Servo Module
4B-50
Figure 4B.40
Typical Wiring of a Touch Probe Configured for Rising Edge Trigger
11309-I
5
4
3
2
1
Servo Module
26LS32
470 ohm
5V common
1000 ohm
+5 V dc
6
BAT/TP
TB1
Probe Contact
Wiring a Probe for Falling Edge Configuration
Figure 4B.41 shows a typical wiring diagram compatible with most probe
designs configured to trigger on the falling edge of the probe signal.
Figure 4B.41
Typical Wiring of a Touch Probe Configured for Falling Edge Trigger
5
4
3
2
1
Servo Module
26LS32
470 ohm
5V common
1000 ohm
+5 V dc
6
BAT/TP
TB1
1000 ohm
pull down resistor
(customer supplied)
Probe Contact
Wiring a Probe to Multiple Servo Cards
Systems with more than one servo module should have their touch probe
connections tied together in parallel. This allows the position to be latched
on all servo modules at the same time with the same input. Only one
power connection needs to be made (with pull up or down resistor). The
other probe connections should be made in parallel on all servo cards.