Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 855)

Error and System Messages
Section 16
16-35
Message Description
PROGRAM ACTIVE An attempt has been made to delete or perform some other operation to a program that was
activated for automatic execution. The program must be deactivated using the {CANCEL
PRGRAM} softkey.
PROGRAM ACTIVE IN ANOTHER PROCESS This dual lathe error appears when one process attempts to open a file for edit, deletion, etc.,
while that file is active in another process.
PROGRAM BEING EDITED An attempt has been made to copy, verify, or perform some other operation on a program that is
still in the edit mode. It is necessary to press the {EXIT EDITOR} softkey from the edit menu to
properly end an editing operation.
PROGRAM BLOCK TOO LONG More than 128 characters were entered into a single block.
PROGRAM CURRENTLY IN USE A subprogram or paramacro program was called that is currently being used to perform some
other operation (such as editing or copying). Typically, this message is the result of attempting
to edit a program that was not properly closed. A program remains in the edit mode until the
{EXIT EDITOR} softkey is pressed from the program edit menu.
PROGRAM NAME TOO LONG An attempt was made to create a program with a program name longer than 8 alphanumeric
characters. If a large, descriptive program name is desired, a comment may be added to the
right of the program name using the {PRGRAM COMENT} feature.
PROGRAM NOT FOUND The program cannot be located in memory. Check to make sure the program name was
correctly entered.
PROGRAM OPEN FOR EDIT IN ANOTHER PROCESS On a dual-processing system, you cannot edit a program that is active in another process. You
will need to switch processes if you want to edit the other program.
PROGRAM REWIND ERROR An attempt to rewind the tape was not successful. Check to be sure that the tape reader is
functioning properly and the tape is on the drive sprockets.
PROGRAM SHOULD START HERE When performing a {MID ST PRGRAM} operation to restart a program, the control has found the
block that the program execution should begin at, and selected that block as the next block to
be executed. That block is the block immediately following the one containing an @.
PROGRAMMED AXIS IS OFF OR DETACHED Part program blocks are attempting to program motions on an axis that has its servos either off
or configured as detached in AMP.
PROGRAMMED G26 DEPTH < TRIGGER TOLERANCE A G26 block is programmed with an integrand less than or equal to the AMPed Adaptive Depth
Trigger Tolerance amount. A block decode error is given and the block will not execute until the
integrand in the block is made larger or AMP is modified to reduce the trigger tolerance.
PROGRAMMED SPINDLE UNAVAILABLE The programmer attempted to program the follower spindle independently (M03, M04, M05, or
M19) while spindle synchronization was active.
PROGRAMS ARE DIFFERENT A program verify operation has determined that the two selected programs are not identical.
PROGRAMS ARE IDENTICAL A program verify operation has determined that the two selected programs are identical
matches.
PROGRMABLE ZONE 2 VIOLATION An attempt was made to move the indicated axis into the area defined by programmable zone 2.
PROGRMABLE ZONE 3 VIOLATION An attempt was made to move the indicated axis into (or out of) the area defined by
programmable zone 3.
PROGRMD G26 DEPTH < TRIGGER TOLERANCE The programmed adaptive depth deflection (hole depth) is less than the probe tolerance value.
You must either increase the programmed block depth, or decrease the AMPed probe tolerance
value.
Q
QPP ANGLE WORD SAME AS AXIS NAME AMP has downloaded an angle word for QuickPath Plus that is the same as an axis name.
AMP must be reconfigured; the angle word cannot be the same as an axis name.
QPP BLOCK FORMAT ERROR Data is incorrectly entered or insufficient data is entered for the control to correctly execute a
QuickPath Plus block or pair of QuickPath Plus blocks.