Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 96)

Section 3A
Primary 9/230 Components
3A-13
Table 3A.F lists the connectors that are used to integrate the analog servo
connections with other modules of the control. If you have purchased the
single axis 9/230 control, only one servo connector (J1), an open loop
spindle connector (TB3), and the touch probe connector (TB2) is available.
Table 3A.F
Typical Processor Module Connection
Connector On Connected To Cable Remark
Module Connector Number
J3 (D shell) 1 Term. Panel AXIS C35 AXIS
J2 (D shell) 1 Term. Panel AXIS C35 AXIS
J1 (D shell) Term. Panel AXIS C35 AXIS
T.P. (TB2) Touch Probe ---- C46 ----
ANALOG OUT (TB3) Spindle Drive C42 Spindle
Remote I/O (P2) PLC Scanner C17 Page 8-19 has details on RIO
(purchased as an option)
1 -- Not available on single axis 9/230 controls
J1, J2, and J3 D-Shell AXIS Connectors
The 9/230 sends drive signals to the servo amplifier through connectors
labeled J1, J2, and J3. Figure 3A.10 shows an end view of connector J1,
J2, and J3 and lists the pin assignments of these connectors.
3A.2.3
Analog Servo Connectors
and Pin Assignments