Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 758)

Section 15B
Replacement Procedures
15B-2
Replacing the Removable Operator Panel (ROP) Interface Module 15B-55
Replacing the ROP Module in the Removable Operator Panel Interface Assembly 15B-56
Replacing the Removable Operator Panel CRT or Keyboard Assemblies 15B-57
Replacing the 9/440 System Module or CNC Assembly 15B-58
Replacing the 9/440 E--Stop String Fuse 15B-60
As we release new versions of executive software for your control, you
will have to install the new software. For the 9/230, 9/260 or 9/290 the
executive software updates come to you on 3 1/2-inch floppy disks. You
can install the executive software update on an:
Allen-Bradley T35, T45, T47, T50, or T60 with MS-DOS 3.3 or greater
installed
IBM XT/AT personal computer or 100% compatible
with MS-DOS 3.3 or greater installed
When you install the update, it uses an external drive for the update, and an
internal drive for a scratch directory. The update requires about 2 MB of
disk space. In this procedure, all variables that are entered by the control
during installation are in italic.
Important: Installing the executive firmware can delete all battery backed
up memory, AMP, and PAL. Make sure you have all necessary
information backed up before you re-install the executive software.
15B.1
Updating the Executive
Firmware