Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 140)

8
1
15
9
11257-I
Section 4A
Primary 9/260 and 9/290 Components
4A-6
Video Monitor Connector
The video monitor connector is used to interface the video monitor with
the control. Figure 4A.6 shows this connector and lists the pin
assignments.
Figure 4A.6
Video Monitor Connector-J8 (has pin sockets) and Pin Assignments
Pin No. Signal Name Pin No. Signal Name
1 GND (SHIELD) 9 RED (L2)
2 RED (L1) 10 GREEN (L2)
3 GREEN (L1) 11 BLUE (L2)
4 BLUE (L1) 12 NC
5 NC 13 CLOCK (2L)
6 CLOCK (L1) 14 H-SYNC (L2)
7 H-SYNC (L1) 15 V-SYNC (L2)
8 V-SYNC (L1)
The CPU board works with the motherboard to process all software
functions of the 9/260 and 9/290 control. You can remove the CPU board
from the enclosure by gently sliding it out. When you replace the board be
sure to line the board with the guide tracks on the top and bottom panels of
the enclosure. Figure 4A.7 shows the CPU board layout.
4A.3
CPU Board for 9/260 and
9/290