Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 750)

Section 15A
Troubleshooting The Control
15A-40
Figure 15A.17
1394 Drive Diagnostics Screen
1394 DRIVES 1394-0-0
SME0
SYSTEM MODULE STATUS
BUS VOLTAGE (Low/hi/OK) ___v
SHUNT TIMEOUT (OK/flT)
TEMPERATURE (ok FLT) OVERCURRENT (OK-FLT)
PHASE LOSS (OK/FLT PRECHARGE (OK/FLT)
GROUND FAULT(OK/FLT) SHUNT UTIL XX %
REGEN UTIL XX %
AXIS MODULE STATUS
GRND OVER BUS OVER
FLT CRNT FLT TEMP
slot 1 OK/FLT OK/FLT OK/FLT OK/FLT
Slot 2 OK/FLT OK/FLT OK/FLT OK/FLT
slot 3 OK/FLT OK/FLT OK/FLT OK/FLT
slot 4 OK/FLT OK/FLT OK/FLT OK/FLT
Axis Module Slot Number
System Module Faults
The following table lists the axis module and system module faults that can
be shown on this screen and gives a description of each. Note that those
items designated with a “**” in this table are only shown if the smart
power (or Series C ) 9/440 hardware is being used in your system. On all
other systems these areas of the screen are left blank.