Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 509)

Section 9A
Operator Interface
9A-42
Figure 9A.24 shows the connectors and terminal block used to make
connections to the HPG interface board.
Figure 9A.24
HPG Interface Board Connectors and Terminal Block
OP14
(IN)
Optical connectors
OP13
(OUT)
From Operator Panel
power supply
+5V dc GND
Rear
Table 9A.U shows the power supply connections to the HPG interface
board.
Table 9A.U
HPG Power Supply Connectors
HPG
Connector Terminal
Connected To Mating
Connector
Cable
Number Remark
BT23 +5V Operator Panel BT03 5V dc C28 Input
GND Power Supply GND Output
Table 9A.V shows the connectors used to make the fiber optic connections
to the I/O ring. Each module connected to the system I/O ring has an
optical transmitter and receiver. Fiber optic cables connect transmitters to
receivers to form the I/O ring. Refer to page 7B-1 for additional
information on fiber optic cables and connectors.
9A.5.1
HPG Connectors