Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 46)

Section
2A
2A-1
Planning Your System Layout
When planning the system layout of your control, take into consideration
the restrictions and specifications covered in this section.
Mechanical system design specifications necessary for cabinet design and
construction are listed in the following sections:
Table 2A.A
To Plan your System Layout
For Information on: See Page
Determining Cable Lengths 2A-1
Meeting Environmental Conditions 2A-1
Designing the Cabinet for Its Environment 2A-3
Reducing Noise 2A-8
Installing the Components 2A-8
When you install the components, refer to page 7A-1 for electrical cable
lengths, and page 7B-1 for fiber optic cable lengths.
ATTENTION: The system installer should consult local and
state regulations for additional installation requirements.
You must install the components inside a cabinet that satisfies the
environmental conditions listed in Table 2A.A. All components must meet
these conditions for you to successfully operate the control.
2A.0
Section Overview
2A.1
Determining Cable Lengths
2A.2
Meeting Environmental
Conditions