Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 136)

Editing Ladder Logic
6-17
Example 1
If you press the right arrow key, [ а а ] , the end of the branch will move to the right. The
branch in the screen on the previous page will then appear as follows.
Press [F1] cUrrent to program this structure.
Note You can achieve the same result by pressing [D] or [F5] from the screen shown on
page 6-16 . You can also use the Command Portal to program a branch. In this case,
with the cursor on the OTE instruction, you would type .EBID .
Add your instruction(s) to the branch. See Adding Instructions to a Branch on page 6-
19 .
At this point you can edit the rung further or press [F9] aCcept .