Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 387)

Channel Configuration
16-9
System Mode Configuration
1. From the Channel Configuration screen, press [F4] Ch0Sys . This displays the
configuration screen for System Mode. Depending on the System Mode Driver you
have selected, you will see a screen similar to the following:
2. Edit the parameters. Refer to the tables below for a description of the parameters.
§ Move the highlight to the parameter you want to change.
§ Either press [F9] Select to toggle the setting of the parameter or (if the
message Enter CFG value: appears near the bottom of the screen) type the
numeric value for the parameter.
§ When you have set the parameters the way you want them, press [F1] Accept .
3. Press [Esc] .