Processor status – Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 437
MicroLogix 1000 and PLC-500 A.I. Series Software Reference
19-6
Processor Status
The processor status screen displays the contents of the processor status file, S2. This
includes fault information that can be useful for troubleshooting.
To display the processor status screen:
1.
From the top level in the ladder editor, press
[F8]
Display
. The function keys at
the bottom of the screen change to show the display options.
2.
Press
[F2]
Prcstat
. The processor status screen appears.
SLC 5/02 and higher processors have more processor status information than can be
displayed on a single screen. Use the
[PgUp]
and
[PgDn]
keys to page through the
status display screens. A description of the bit or word under the cursor is displayed
near the bottom of the screen.
For more information on the Processor Status Screen, refer to
Processor Status
Configuration
in
Chapter 3 - Configuring the SLC 500 CPU and I/O Modules
. For
more information on the status file, refer to
Appendix A - Programming Reference for
Packaged Controllers
in the
Instruction Set Reference
.
Command Portal keys
for this function:
.DP
Note: Fault bits cleared
by
[F4]
Clrfalt
.