Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 83
Data Table Addressing and Editing
4-15
You can monitor the Global Status File. From the Processor Status File display (see
page
4-12
), press
[F4]
Glbstat
. A screen like the following appears.
The following function keys are active on this screen:
[F1]
Radix
Allows you to change the display radix to the following options:
[F1]
Binary
[F2]
Integer
[F3]
BCD/Hex
[F4]
Ascii
[F5]
Octal
[F6]
Des
Start the instruction description editor for the highlighted address
[F10]
Help
Displays information about using this screen.
You can use the data table monitor to change address values. In the Global Status File,
you can only change the Transmit Word, the Transmit Enable Bit, and the Transmit
Receive Bit. To change an address value, move to the bit or word you want to change.
At the bottom of the screen, the system indicates the address corresponding to the
cursor location. Type the new value for the bit or word, and press
[Enter]
or one of the
cursor keys. The system changes the value of the address, and displays the new value
on the monitor screen.