Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 505)

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
B-iv
Type of Error Description
Old Database Version
Errors caused when the database you are attempting to open was
created by an older version of RSI software.
Open Errors caused when DOS cannot open a file. The reasons why
DOS may not be able to open a file depend on whether the
file is being opened for reading or writing.
•
If the file is being opened for reading, the most likely
reason for this error is that the file does not exist. On a
network, someone else may have the file locked.
•
If the file is being opened for writing, the most likely
problem is that the subdirectory specified does not exist.
The file may already exist, and have the Read Only
attribute set. On a network, someone else may have the
file locked.
Write Errors caused when DOS cannot write data to a file. The disk is
probably full.
Error Closing File the disk is probably full.
Error Deleting File the file does not exist, is open, or is a directory. It could
also have the Read Only attribute.
Unlink Error “Unlink” is a technical term for deleting a file.
Error deleting directory You cannot delete the current directory, any directory that
contains files or directories, the root directory, or a directory
that does not exist.
Rename Errors In order to rename a file successfully:
•
the file must exist.
•
the Read Only attribute must not be set.
•
the new name must be in the same subdirectory and on
the same drive.
•
the new name must not already exist.