Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 223)

Searching
10-5
Search for an Instruction Type, Address, Symbol,
or Edit Zone
You can use the Search Path Specification Window to search for an instruction type,
address, symbol, or edit zone.
Indirect addresses (SLC 5/03 OS302 and SLC 5/04 OS401 only) may be used to specify
a search address, but the search will only find instances of the address in indirect
format. (For example, if the value in N7:0 is 12, and you search for N24:[N7:0], the
search will find occurrences of N24:[N7:0], not N24:12.) The software will, however,
find addresses used as a component within an indirect address. For example, a search
for N7:0 would find the address F8:[N7:0], assuming this address exists.
Indexed addresses (SLC 5/02, 5/03, 5/04, and MicroLogix processors) may be used to
specify a search address, but the search will ignore the index and find all occurrences of
the specified address. For example, a search for #N7:10 would find only occurrences of
N7:10, regardless of the offset value for indexed addressing.
To search for an address or symbol:
1. Select [F1] Search . The function keys at the bottom of the screen change to show
the search functions.
2. Select [F2] New . The Search Path Specification Window appears.
3. Press [
б б
] to move the cursor to the Ins Type field. The menu bar at the bottom of
the screen will list instructions.
Command Portal keys
for this function:
.SN