Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 217
Using the Database Editor
9-27
2.
Select
[F2]
Search/Replace a Range of Addresses
. The system prompts you for a
search address. This address can be a single address, or you can use wildcard
characters in the address to select a range of records
3.
Type the address whose record you want to move (including any wildcards). Press
[Enter]
. The system asks you for the new address (where you want the records to
go). If you use a wildcard in the search address, you must use that wildcard in the
new address. For instance, if you copied C5:*, you could select C25:* as the new
address, which would move all the records in C5 to C25.
4.
Type the address (including wildcards) where you want to move the records. Press
[Enter]
.
5.
The system asks if you want to automatically search and replace the records. If you
want to move all the records, select
[F1]
Yes
, and the system will automatically
move the records. If you want to confirm each address, select
[F5]
No
, and the
system will prompt you record by record, asking if you want to move the record to
the new address. If records already exist at the new addresses, the system prompts
you before changing the address for the records, warning that you are about to
replace existing records.