Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 265)

Creating and Printing Reports
11-29
3. Press [Ins] to add a range of files to the list. A prompt appears asking you for the
low address of the range you want to print.
Type the first address in the range, and press [Enter] .
4. A prompt appears, asking you for the high address of the range you want to print.
Type the last address in the range, and press [Enter] . (If you want to print only
one address, enter that address as the low address and, at the high address prompt,
press [Enter] without typing an address.)
5. Repeat steps 3 and 4 for any additional ranges you want to print.
6. To delete a range, use the up and down arrow keys to highlight the range to delete,
and press [Del] .
7. To save the ranges and exit, press [Esc] .
8. To enable the saved address list, press [F2] Use Address List to toggle the
parameter to Yes .
Note The range of addresses can include any valid data table address. For example:
O:0 - N7:255
B3:0 - B3:255