Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 80)

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
4-12
You can use the data table monitor to change address values. To change an address
value, use the arrow keys to move the cursor to the bit or word you want to change. At
the bottom of the screen, the system indicates the address corresponding to the cursor
location. Type the new value for the bit or word, and press [Enter] or one of the cursor
keys. The system changes the value of the address, and displays the new value on the
monitor screen.
!
Typing a value and then pressing a cursor key will cause the value to be entered in
the data table.
!
Changing data table values while online can cause unexpected machine movement,
possibly resulting in personal injury or equipment damage. USE EXTREME
CAUTION WHEN CHANGING DATA TABLE VALUES!
Monitoring the Processor Status File
When monitoring the processor status file, the file monitor screen appears as follows: