Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 346)

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
15-10
DH+ Direct Device
Fixed,
SLC 5/01 SLC 5/02 SLC 5/03 SLC 5/04 Page
Serial to 1770-KF2B • 15-26
1784–KT/KT2 • 15-11
1784–KL •
15-12
1784–PCMK •
15-14
1784–KTX/KTXD •
15-15
S-S Technologies, Inc 5136-SD/SD2 •
15-22
WinLinx driver •
15-18
RSI LAN Logistics •
15-24
RSI LAN Logistics NETBIOS
•
15-25
Ethernet Device
Fixed,
SLC 5/01 SLC 5/02 SLC 5/03 SLC 5/04 Page
A-B Ethernet to DH+ • 15-27
WinLinx Driver Ethernet to DH+ • 15-28
Serial Port to A-B 1747-PIC Interface Converter
The 1747–PIC Interface Converter supports DH-485 communication only. Note that
the SLC 5/04 processor only supports DH–485 communication via channel 0 (RS–232).
See Allen-Bradley’s SLC 500 Modular Hardware Style Installation and Operation
Manual , Publication 1747–6.2 for connection information.
The table below describes the parameters that become available when you select this
device on a DH-485 network.
Parameter Description
[F1] Computer/
Terminal Address
enter the station address (0-31 decimal). This address must be
unique on the network.
[F4]
Communications
Port
designates which communication port on your computer to use.
If using COM 3 or 4, you must enter the port address and IRQ.
Refer to page
15-32 for information on setting the COM Port.
[F5] Baud rate select the baud rate of the DH-485 network