Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 34)

Introduction
1-23
Communications Hardware
You can transfer programs to and from the SLC 500 and monitor online operations
using a Rockwell Software product and one of the following protocols depending on
your SLC 500 processor: DH-485, DH+, or RS-232. Refer to Allen-Bradley’s data
sheets or hardware manuals to determine valid network configurations.
For information on configuring communications hardware to operate with
PLC-500 A.I., refer to Chapter 15 - Configuration for Online Communications .
NT Users: Only serial drivers (except the 1747-PIC) will work when running PLC-
500 A.I. under Windows NT. RSI is working on a version of the software that will
contain special drivers to communicate through RS Linx™. This will allow you to
communicate using any of the drivers available with RS Linx.