Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 63)

Configuring the SLC 500 CPU and I/O Modules
3-7
To delete a card from the configuration, highlight the card and select [F6] Delete . You
can place the last line you deleted at the highlighted location by pressing [F7] Undel .
If this location already has a card assigned to it, the previously deleted card will replace
the current one.
[F8] spioCfg brings up the advanced I/O configuration window for the highlighted
card. This only applies to SLC 5/02 processors and higher using certain specialty I/O
cards.
Note The following applies to the Configuration Screen (existing projects) as the [F9]
Monitor key is unavailable on the Definition Screen:
You can also enter descriptions or device assignments for I/O points on discrete
modules. To enter these descriptions:
1. Highlight the card. Press [F9] Monitor to display the I/O points on the card.
2. You can attach device descriptions to the I/O points. Press [F7] deVice to enter a
device. Press [F9] desCrib to enter description text only.
3. You can press [F8] disMode to toggle display modes for device or description text.
4. To return to the module list, press [Esc] .
Exiting the Editor
Press [Esc] to back out through the menu structure. When you exit the top menu of the
editor after changing the configuration or the ladder logic, PLC-500 A.I. will inform
you that the program and/or data has changed. A dialog box asks you whether you
want to save the changes. Press [F1] Yes to save the changes. A screen similar to the
one below appears. The options you are given depend on the type of processor.