Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 359)

Configuration for Online Communications
15-23
Communication Medium
Parameter DH+ / DH-485 Bridged DH+
[F9] LOCAL not available displays the Configure Local
Remote Settings menu. From
this menu, press
[F1] Network
Mode to toggle between LOCAL,
REMOTE, or DH+ ROUTING.
Refer to
DH+ Direct
Local/Remote Settings on page
15-29 .
*For information on excluding memory addresses to avoid conflicts with the interface
card, refer to the Hardware Interface Configuration Guide .
A-B Ethernet DH+ to 1785-KA5
The table below describes the parameters that become available when you select this
device.
Parameter Description
[F4] 5820-EI Ethernet Address enter the IP address of the EI module
[F5] PLC-5/250 Module Type toggle between RM or KA (5130-RM, 5130-KA).
Set to the module type of the -5/250 that has the
DH+ channel connected to the 1785-KA5
[F6] PLC-5/250 Channel toggle between 2 and 3. Enter the channel number
of the DH+ network you want to connect to.
[F7] PLC-5/250 Pushwheel This is available only if the PLC-5/250 Module Type
is set to KA. Toggle from 1 to 8 to match the
setting of the pushwheel of the KA module whose
channel is connected to the -KA5.
[F8] 1785-KA5 DH+ Address enter the DH+ station address of the 1785-KA5
module
[F9] DH+ Link ID enter the link ID of the DH+ network to which the
1785-KA5 module is connected