Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 110)

MotionSuite™ Series Machine Controller Software Manual Chapter 4: File Manager
4-53
Note:
1. When a main program is copied, the sub-program, such as the table format program,
is also copied simultaneously.
2. It is not possible to copy a program to an existing DWG/Function program.
4.9.2 Setting Disable
Follow the procedures below to set up the program disable function.
a. Click the program in which the disable is to be set up.
b. Select Enable/Disable (E) from Edit (E) in the File Manager menu.
Or, select it from the pop-up menu.
If the selected program is being set up for disable, the disable is released now. If it is
not being set up for disable, the disable is set up now.
Note:
Enable/Disable can be set up only for the DWG/Function program.