Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 246)

MotionSuite™ Series Machine Controller Software Manual Chapter 7: System Data Definition
7-73
Note:
The results of a fault confirmation and reset are reflected immediately in the PLC.
a. Fault Confirmation
This function confirms unconfirmed faults.
a.1 Move the cursor to the fault to be confirmed.
a.2 Select Confirm (E) from Status (S) in the Failures Menu.
a.3 Select the Yes (Y) button in the message box.
a.4 Select the OK button in the message box. The Status box changes from
“unconfirmed” to “confirmed.”
b. Fault Reset
This function resets confirmed faults.
b.1 Move the cursor to the fault to be reset.
b.2 Select Reset (R) from Status (S) in the Failures Menu.
b.3 Select the Yes (Y) button in the message box.
b.4 Select the OK button in the message box.
b.5 The Status box changes from “confirmed” to blank.
Note:
Reset is not possible when F (Fault Relay ON/OFF) is defined in the Timing box of the
Failures tab.
7.8.5 Display of Current Faults
Fault data can be displayed in the Current tab if a fault occurs due to data set in the
Failures tab. If a change occurs during application in the fault monitor data, the PLC
resets all heretofore fault trace data, and the fault data reflected in the content of the
newly defined Failures data is displayed. The items in the Current tab are as follows:
1. Relay
1 2 3 4 5