Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 248)

MotionSuite™ Series Machine Controller Software Manual Chapter 7: System Data Definition
7-75
This column displays the time at which a fault recovered. Faults not displaying a
date and time indicate that they are currently not recovered.
6. Failure Name
This column displays the failure name. Failure names are set in the Failures tab.
7.8.7 Saving Fault Monitor Data
This function saves fault monitor data. In the on-line mode data is saved into both the
PLC and hard drive, and into the hard drive only in the off-line mode. Save fault mon-
itor data as follows:
a. Select Save (S) from File (F) in the fault monitor definition menu.
b. Select the Yes (Y) button in the Failures message box.
Note:
The error detection message box is displayed when a save fails. Remove the cause of the
error, and save again.
7.8.8 Deletion Fault Monitor Data
This function deletes fault monitor data. In the on-line mode, fault monitor data is
deleted from both the PLC and hard drive, and from the hard drive only in the off-line
mode. Delete fault monitor data as follows:
a. Select Delete (D) from File (F) in the fault monitor definition menu.
b. Select the Yes (Y) button in the Failures message box.
c. All the fault monitor data is deleted.
7.8.9 Closing Fault Monitor Data
Setting/display processing of the fault monitor data is closed by closing the fault mon-
itor window. To close the fault monitor window, select Close (C) from File (F) in the
fault monitor menu.