Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 272)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-24
Data (D)
Set (S) Clears a register value at a set numerical value 8.1.5
ON (N) Cannot be used in this version —
OFF (F) Cannot be used in this version —
Format (C)
DEC (D) Displays a register in decimals 8.1.5
HEX (H) Displays a register in hexadecimals 8.1.5
FLOAT (F) Displays a register in real numbers 8.1.5
LONG (L) Displays a register in 32-bit integers 8.1.5
BIN (B) Displays a register in binary form 8.1.5
ASCII (A) Displays a register in ASCII characters 8.1.5
Autonumbering (A)
AUTO (A) Executes automatic numbering of all registers 8.1.4
D, M (I) Executes automatic numbering of D and M registers 8.1.4
Symbol Link (L) Executes upper level symbol link 8.1.4
Set Top Register (R) Cannot be used in this version —
Command (C)
RELAY (R) Displays list of available commands 8.2.3
8.2.5
ART (A)
LOGIC (L)
CONTROL (C)
Displays list of available commands 8.2.3
8.2.5
FUNCTION (F)
MOVE (M)
DDC (D)
TABLE (T)
MOTION (M)
SFC (S)
Debug (G)
SYNC (S) Synchronous adoption of present value 8.2.8
HOLD (H) Temporarily stops the currently adopted value 8.2.8
DIS-ON (N) Designates coil command disable ON 8.2.6
DIS-OFF (F) Designates coil command disable OFF 8.2.6
ENABLE (E) Releases coil command disable designation 8.2.6
REFER (R) Opens reference program window 8.2.7
BACK (B) Displays programs opened by REFER 8.2.7
Table 3: Ladder Program Window Menu (continued)
Menu Function Item No.