Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 449)

MotionSuite™ Series Machine Controller Software Manual Chapter 12: Printing
12-29
12.9.7 M Register List Sample
1. Register Number
The register number is printed here.
2. Cross-Reference Data
Cross-reference data is printed for register numbers. Cross-reference data in
which $, &, or @ is printed at the end indicates writing of the register within the
program. The meanings of the writing types are as follows:
$ : Coil commands (— —) and storage commands ( ⇒).
& : Transmission commands such as MOVW, XCHNG< ROTL, ROTR,
etc.
@ : Pulse, total registers.
3. Symbol
Symbols defined in the register are printed here.
4. Comment
Comments defined in the register are printed here.
5. Register Range
The range of the register on the currently printed page is printed here.
1
2
3
4
5