Yaskawa MotionSuite Series Machine Controller Software Manual User Manual
Page 403
Advertising
MotionSuite™ Series Machine Controller Software Manual
Chapter 11: Debug Operation
11-5
11.1.4 Debug Function Keys
The debug commands can also be executed by function keys. Refer to Item 11.1.3:
“Debug Tool Icons” for each key’s function.
11.1.5 Debug Status Bar
The debug status bar is displayed at the bottom of the motion editor window to
indicate the status during the debug operation. The following status information can be
displayed simultaneously.
Debug mode:
Debug operation mode is enabled
Running:
Debug is being operated normally
Hold:
Moving command is discontinued
Abort:
Debug operation is being reset
Alarm:
Debug operation error occurs
Break:
Debug operation stopped at break point
Advertising